Body electrification
Beck Therapy
Energetic-Medicine researcher1925-2002
WHAT YOU DO:
3. Apply your magnetic pulse generator for about 20
minutes daily by
positioning and pulsing coil over
lymph nodes and internal organs.
Pulse each time it
recharges at several second intervals. Pulses of
high intensity time-varying magnetic flux generate a
measurable back
e.m.f. in adjacent tissue thus
neutralizing any residual germinating
and incubating
pathogens. Without this step, sufferers have been known
to sometimes reinfect themselves. Conventional permanent
magnets
positively will not work.
4. Drink as
much ozonated water as you can comfortably ingest
daily.
You must generate fresh ozone yourself each
time and drink immediately
since ozone has a
half-life of only a few minutes. All known pathogens
and cancers are anaerobic. Ozone aids their
elimination by oxidation
and speeds your
detoxification and recovery with no discomfort.
Consuming ozone water flushes neutralized pathogens,
wastes and toxins
from your system.
THESE
FOUR STEPS WORK SYNERGISTICALLY AND ALMOST MAGICALLY AND
SHOULD
BE USED TOGETHER. AVERAGE TIME FOR RECOVERY IS
UNDER A MONTH.
If you are not technically oriented,
you may skip the following.
HOW AND WHY YOU must DO
THIS:
1. The
blood electrifier and silver colloid maker are usually
combined
in one small plastic box, typically 3-3/4" X
2-1/4" X 1" (cigarette
pack size) containing one
outlet for wrist electrodes and a second
outlet for
colloid making. A single 9 volt transistor radio battery
drives a voltage tripler, and a single-IC-chip switches
the 27 volts
from negative to positive 3.92 times
each second. A biphasic square
wave with sharp rise
time output is fed to a 3.5 mm jack connecting to
two
3/32" stainless steel electrodes 1" long each covered
with two
layers of 100% cotton flannel saturated with
dilute salt water. A
potentiometer allows users to
adjust output until comfortable. Red and
green LED's
show polarity reversal (essential for safe blood
electrification) and overall system functioning. A
grain-of-wheat lamp
indicates current flow when
making ionic colloid. Precise electrode
locations are
determined by carefully feeling arterial pulse points on
opposite insides of same wrist and positioning saturated
electrodes
precisely along the paths where arteries
come closest to surface.
Locations are critical,
since objective is to supply maximal current
into
blood and not waste it in surrounding flesh. Typical
impedance
measured from electrode-to- electrode may
be as low as 2000 ohms.
Adjust output for strongest
comfortable level. Schematics, parts lists
and
detailed instructions appear in [elsewhere in these
lecture
notes]. Anyone can build his own system: you
need buy nothing except
replacement batteries.
However commercially available systems are
inexpensive, reliable, and are usable immediately.
2. Ionic Silver Colloids of excellent
quality and freshness are easily
user-made as follows
- Pure silver (99.9%) 14 gauge electrodes,
providing
anode and cathode about 6" long, are immersed in an 8 OZ
glass of room-temperature water (tap or distilled) and
the 27 volt DC
output is applied for about 3 minutes
in tap water and 20 minutes in
distilled water or
until water appears milky. Stir and drink
immediately
two or three times daily. I ozonate the water while
making
colloid and drink the combination immediately.
Some prefer "golden"
colloids, easily made by using
only heated (150 degrees F) distilled
water in Pyrex
containers with electrodes activated for ~20 minutes.
Store silver colloid in dark brown bottles. Keep out of
light and do
not refrigerate.
3. MAGNETIC
PULSER: This extremely useful tool neutralizes active,
hibernating or incubating pathogens being normally
processed in lymph,
spleen, liver, skin, kidney,
stomach muscles and other tissue. It is
easily made
by purchasing or winding a ~2.5 millihenry coil and
driving it with a 35 to 70 Watt-Second (Joules)
electronic flash or
"strobe". (A Joule is (1/2 CV^2)
where C is in microfarads and V is in
Kilovolts.) A
self-wound inductance coil of ~130 turns of 14 or 16
gauge, plain enameled magnet wire works well. A 2.5 mH
audio speaker
cross-over coil is prettier. The coil
is simply wired between one
electrode of the strobe
flash lamp and its capacitor. The device, if
self-made, costs about $27 and is vasty more powerful
than $5000 to
$7O00 commercial devices of far less
measurable power. The coil kicks
a steel washer
several feet into the air when pulsed thus showing the
"occult" (invisible) energy going into your body during
use. A typical
finished device (Future Tech Today,
USA 1-(866)-747- 7447) tests 600
mfd, 330-350V, 36
WS, 21,429 Gauss, 105 Amperes peak, 17,850 Ampere
Turns pulse rise time ~1.8 microseconds, pulse duration
~2.6
milliseconds, penetration ~8" in tissue. It and
its AC power supply
fit in a box 1-1/2" X 2-5/8" X
4-1/2" with an external applicator coil
2-3/4"
diameter X 1-3/8" thick on a 4' cord. (These details are
offered for professionals only.)
4. OZONIZED
DRINKING WATER: Before adding this final step to the
"magic four", we had some very uncomfortable full-blown
AIDS patients
while they were detoxifying. All are
now completely well and symptom
free. By simply
drinking ozone-charged water, most of the benefits of
ozone use such as insufflation (ozone enemas),
autohemotherapy, ozone
injections and blood bubbling,
Oxygen Bars and Hyperbaric Oxygen
chambers were
easily surpassed and made simple and inexpensive. Tanks
of "medical oxygen" (identical to welding oxygen)
require medical
prescriptions. Ozonized water is made
from oxygen in ambient air and
costs nothing. MAKING
YOUR OWN: You can purchase ozone generators
legally
in tropical fish (aquarium) stores. Preferred is the 200
ML
Sander (brand) ozonizer used with an aquarium
aerator pump. Air pumped
through a bubble-making
"stone" is passed through chilled water.
Depending on
the strength ozone maker you buy, water becomes
"saturated" in a few minutes and must be drunk
immediately. You can
see an increase in % blood
oxygen saturation which often reaches 100%
within
minutes. Do NOT use ultra-violet (cheapest but almost
useless)
generators. Use ONLY cold-corona high
voltage ozonizers. Construction
and use is fully
explained in my main paper.